扒开双腿猛进入喷水高潮视频,日本在线 | 中文,欧美疯狂做爰3XXX高清,丰满熟妇大肉唇张开

Product List
Contact us Tina
Changzhou Qunchuang Electronical Co.,Ltd.
Tel:(86)0519-83888823
E-mail:tina@qc-parts.com
info@qc-parts.com
Website:
http//www.tyin-investment.com
Address:BLDG 2, NO.18 Qingjiang Rd.,Xinbei DIST.,Changzhou Jiansu,China
News center
Current location:Home—News center
Three points of pressure sensor multimeter measurement
release time:2018-6-12  Views:865

Pressure sensors are usually tested after they are produced. Some customers are also used to testing them when they get pressure sensors. However, customers generally do not have system components and measurement tools to perform tests. Generally, they use a multimeter to perform some tests. Testing. How to use a multimeter for simple detection?
Measuring the pressure sensor with a multimeter can only perform some simple tests, and the results of the test can only provide a reference. Multimeter measurement can roughly carry out three tests.
One is the detection of the bridge, mainly to detect whether the sensor's circuit is correct, there is no error, generally is the detection of Wheatstone's full-bridge circuit, we use the multimeter's Ohm file to measure, the amount of impedance between the input terminals, And the impedance between the output terminals, these two impedances are the input and output impedances of the pressure sensor.
If the measured impedance is infinity, then prove that the bridge is disconnected, indicating that there is something wrong with the sensor or the definition of the pin is not correct.
The second is the zero point detection, which is measured with the voltage profile of the multimeter. We generally measure the zero output value of the sensor when no pressure is applied. This output is typically a mV voltage. If the measurement exceeds the sensor's specifications, then the sensor's zero deviation is out of range.
The third is pressure detection, the simple method is: We supply power to the sensor, blow the pressure sensor's air hole with the mouth or gas, and then use the multimeter's voltage file to detect the change of the voltage value at the output end of the sensor. If the relative sensitivity of the pressure sensor is large, this amount of change will be significant. If there is no change at all, then you will need to use pressure sources to apply some pressure measurements.
Using the above three aspects, it is basically possible to detect the general condition of a pressure sensor. If the detection needs to be more accurate, a standard pressure source needs to be used to deliver the pressure to the sensor, and the sensor is calibrated according to the magnitude of the output pressure and the variation of the output signal value. With the conditions permitting, temperature detection of related parameters is performed.

  • Previous:Three common signal forms for sensor output
  • Next:NTC thermistor temperature sensor installation and use requirements
  • Copyright @ 2018 . All rights reserved. Changzhou QunChuang Electrical Co. Ltd.
    玉田县| 肃北| 武定县| 巩义市| 海晏县| 巨鹿县| 多伦县| 鄂温| 岗巴县| 新平| 水城县| 海宁市| 青龙| 合山市| 遂平县| 如皋市| 环江| 津市市| 黑龙江省| 同心县| 安庆市| 遂溪县| 太保市| 沈丘县| 晋宁县| 昌邑市| 武胜县| 安平县| 浮山县| 长乐市| 云浮市| 丘北县| 疏勒县| 台东县| 佛坪县| 平昌县| 云浮市| 平和县| 天祝| 乡城县| 云浮市|